Have ideas to improve npm?Join in the discussion! »

    pimatic-dht-sensors

    0.9.3 • Public • Published

    pimatic-dht-sensors

    Support for the DHT11 and DHT22 temperature and humidity sensor.

    This plugin requires the BCM2835 library to be installed on your Raspberry Pi before you can actually use this module.!

    Plugin Configuration

    Add the plugin to the plugin section:

    { 
      "plugin": "dht-sensors"
    }

    Device Configuration

    Add a DHTSensor device for your sensor to the devices section. To initialize the sensor, you have to specify the sensor type and the GPIO pin where the sensor is connected to. It should work for DHT11, DHT22 and AM2302 sensors. The type property need to bet set as follows:

    Value Sensor
    11 DHT11
    22 DHT22 or AM2302

    By default, the WiringPi pin numbering scheme is used assuming a Revision 2 board which is identifiable by the presence of the 2 mounting holes next to the ends to GPIO pin header. Alternatively, you can set the pinType to "BCM GPIO" for BCM pin numbering or "WiringPi R1" for WiringPi pin numbering on a Revision 1 board.

    {
      "id": "my-sensor",
      "name": "dht22 example",
      "class": "DHTSensor",
      "type": 22,
      "pin": 7,
      "interval": 60000
    }

    Install

    npm i pimatic-dht-sensors

    DownloadsWeekly Downloads

    18

    Version

    0.9.3

    License

    GPL-2.0

    Last publish

    Collaborators

    • avatar
    • avatar